一、攪拌車拖輪是干什么的?
1、 What is a mixer tug for?
攪拌車拖輪是個軸承,用這個把罐體支撐起來,它是與攪拌車是一體的,輔助攪拌。
The mixing truck tugboat is a bearing, which is used to support the tank. It is integrated with the mixer to assist mixing.
二、攪拌車液壓泵怎么換油?
2、 How to change oil for hydraulic pump of mixer truck?
一般不建議自己換,直接到售后點找人事更換,而且使用的油必須符合要求,不然對設備損害很大,使用壽命也會大大縮短,應更換合理標號的液壓油。
Generally, it is not recommended to replace it by yourself, but go directly to the after-sales point to find professional personnel for replacement. Moreover, the oil used must meet the requirements, otherwise the equipment will be greatly damaged and the service life will be greatly shortened. Therefore, the hydraulic oil with reasonable label should be replaced.
攪拌車上裝你應該了解的7個小常識
Seven common sense that you should know about mixing truck
三、水泥攪拌車罐體填充率跟罐體的傾角有什么關系?
3、 What is the relationship between the tank filling rate and the inclination angle of cement mixer truck?
目前攪拌車傾角在12度左右,填充率為63%左右。傾角不好測量,填充率也很難計算。目前銷售攪拌車都以有效攪拌容積為準。
At present, the inclination angle of mixer truck is about 12 degrees, and the filling rate is about 63%. The inclination angle is not easy to measure and the filling rate is difficult to calculate. At present, the sales of mixer truck are based on the effective mixing volume.
四、水泥自動攪拌車罐不轉,轉開了沒力而液壓油從油箱加油口噴出來是什么原因?
4、 What is the reason why the tank of the concrete mixer doesn't rotate and the hydraulic oil sprays out from the fuel port of the oil tank?
液壓一個進一個回,進沒力可能是油泵封閉部分壞了。回油沖,可能是油泵封閉腳墊壞了,可以換個腳墊試試。
The hydraulic pressure enters and returns one by one. The inlet force may be due to the broken sealing part of the oil pump. Return oil flush, it may be that the oil pump sealing foot pad is broken, you can change a foot pad to try.
五、水泥自動攪拌車攪拌桶的轉速是多少?
5、 What is the rotational speed of the mixing bucket of the concrete mixer truck?
進料時攪拌筒的轉速:6—10轉/分;攪拌時攪拌筒的轉速:6—10轉/分。
The rotational speed of the mixing drum during feeding is 6-10 rpm, while that of the mixing drum is 6-10 rpm.
六、8-12方的水泥自動攪拌車進料口到地面距離是多少?
6、 What is the distance between the feeding port and the ground of 8-12 m3 concrete mixer truck?
一般8-12方的攪拌車整車高度大概在3.8米左右,進料口距離地面就有3.5米左右,具體情況取決于不同的車型。
Generally, the vehicle height of 8-12 square meters mixer is about 3.8 meters, and the distance between the feed inlet and the ground is about 3.5 meters, depending on different models.
七、水泥攪拌車怎么清洗罐?
7、 How to clean the tank of cement mixer?
攪拌車配的水箱,每次卸完料后就應該將水放入罐體內(nèi),在返回時攪拌行駛,到攪拌站后再將水排出接料。罐體外表應該在水箱加水時即可順便清洗。當然也可以直接用水箱內(nèi)的水清洗。如果水泥漿已經(jīng)凝固,罐體內(nèi)找的清罐,外表凝固用草酸刷洗就行了。
The water tank equipped with the mixer truck should put the water into the tank after unloading each time. When returning to the tank, the water should be discharged to the mixing station to receive materials. The surface of the tank should be cleaned when the water tank is filled with water. Of course, it can also be directly cleaned with water in the water tank. If the cement slurry has solidified, find a professional cleaning tank inside the tank, and brush the surface with oxalic acid.
上一篇:上料攪拌一體機如何自行添加潤滑油?
下一篇:小型商砼自動攪拌車的配置有哪些?