水泥自上料攪拌車發動機過熱是非常危險的，運氣不好可能會毀壞發動機。在高速公路上高速行駛或汽車爬坡時，如果水溫表指針進入紅區、保持高位或在紅區反復振動，必須采取應急措施。

It is very dangerous for the engine of the cement self loading mixer to overheat, and bad luck may damage the engine. Emergency measures must be taken if the pointer of the water temperature gauge enters the red zone, remains high or vibrates repeatedly in the red zone when driving at high speed on the expressway or when the car climbs a slope.

如果在普通道路上發動機過熱，應盡快降低車速，將車開到樹蔭下，或開到相對涼爽的地方，停車。打開發動機罩，讓發動機怠速運轉，等待發動機溫度逐漸恢復正常。待發動機水溫恢復正常后，關閉發動機。

If the engine overheats on ordinary roads, reduce the speed as soon as possible, drive to the shade of trees or to a relatively cool place, and stop. Open the engine hood and allow the engine to idle, waiting for the engine temperature to gradually return to normal. Turn off the engine after the engine water temperature returns to normal.

然后稍等片刻，待發動機水溫充分下降后，再檢查發動機冷卻水量。此時發動機的冷卻水多為嚴重不足。按規定量補充冷卻水后，再次檢查冷卻系統。確認無其他故障后，即可啟動發動機繼續行駛。

Then wait for a while, and check the engine cooling water quantity after the engine water temperature drops sufficiently. At this time, the cooling water of the engine is mostly seriously insufficient. Check the cooling system again after replenishing the cooling water according to the specified amount. After confirming that there are no other faults, start the engine to continue driving.

如果在高速公路上發動機過熱，你必須立即打開所有的加熱器并打開窗戶，車內會熱得要命。因為暖空氣有助于冷卻水散熱，所以可以大大降低冷卻水的溫度。這將使您能夠繼續駕駛，找到非常近的高速公路出口，并將汽車停在的地方。

If the engine overheats on the highway, you must immediately turn on all the heaters and open the windows. The car will be terribly hot. Because the warm air helps the cooling water to dissipate heat, it can greatly reduce the temperature of the cooling water. This will allow you to continue driving, find very close highway exits, and park your car in a safe place.

接下來，只需按照上述方法降低發動機溫度即可。注意非常好不要把車停在路邊，以免影響交通或被車撞到，車必須停在的地方。

Next, just lower the engine temperature as described above. Attention is very good. Do not park the car on the roadside to avoid affecting the traffic or being hit by the car. The car must be parked in a safe place.

此外在特定的工作環境中，發動機的水溫不可避免地過高。用于水泥自上料攪拌車的冷卻水量可能明顯不足。補充規定量的冷卻水后，檢查冷卻系統以確保沒有其他異常，啟動發動機，然后繼續操作。另外，檢查水箱的百葉窗沒有被異物堵塞，風扇葉片是否運轉，發動機皮帶沒有打滑以及發動機水泵是否運轉。

In addition, in a specific working environment, the water temperature of the engine is inevitably too high. The cooling water used for cement self loading mixer may be obviously insufficient. After replenishing the specified amount of cooling water, check the cooling system to ensure that there are no other abnormalities, start the engine, and then continue the operation. In addition, check whether the louvers of the water tank are not blocked by foreign matters, whether the fan blades are running, whether the engine belt is slipping and whether the engine water pump is running.

上面的介紹的有關攪拌車公路行駛時發動機過熱很危險趕緊應對的內容，希望每個人都對此有所了解。如果遇到此問題，可以使用上面的方法正確它。關注我們f3328.cn，給您推送更多更詳細更新的資訊！

I hope everyone can understand the above content about how to deal with the dangerous overheating of the engine of the mixer truck when driving on the road. If you encounter this problem, you can use the above method to correct it. Follow us at www.sdzkjf Cn, to push you more detailed and updated information!