1.自上料水泥攪拌車所運輸?shù)幕炷烈ＷC其質量及塌落度符合混凝土行業的標準及要求。
1. The concrete transported by the self loading cement mixer truck should ensure that its quality and slump meet the standards and requirements of the concrete industry.
2.攪拌車在道路上行駛，其上裝的加長料槽一定要放置在卸料溜槽的支架上并用掛鉤固定好，不允許掛在主排料槽上工作，主卸料槽要旋轉到固定的位置，拉下定位手柄，用鎖緊手柄將彈簧變幅組織鎖緊，避免由于不固定而晃動，造成傷人及其它事故。
2. When the mixer truck is driving on the road, the extended material chute installed on it must be placed on the bracket of the discharge chute and fixed with a hook. It is not allowed to work on the main discharge chute. The main discharge chute should be rotated to a fixed position, pulled down the positioning handle, and locked with the locking handle to prevent shaking due to lack of fixation, causing injury and other accidents.
3.自上料水泥攪拌車上裝設備連續工作時間不能超過8個小時。
3. The continuous working time of the equipment installed on the self feeding cement mixer truck shall not exceed 8 hours.
4.大型自上料水泥攪拌車在混凝土運輸過程中上裝罐體不能停轉，否則會造成混凝土凝結，而且停轉后重新啟動時會對液壓系統和減速機造成沖擊，導致液壓泵和馬達的損壞。
4. During the transportation of concrete, the large self loading cement mixer truck cannot stop when loading the tank body, otherwise it will cause concrete condensation, and restarting after stopping will cause impact on the hydraulic system and reducer, leading to damage to the hydraulic pump and motor.
5.攪拌車在卸料的時候，如果發現混凝土水分蒸發過多，塌落度偏低，不能滿足質量要求，可以適當?shù)耐迌?nèi)加水，然后以10-14轉/分的速度旋轉30分鐘后再卸料，讓混凝土充分?jǐn)嚢琛?/div>
5. When the mixer truck is unloading, if it is found that the concrete moisture evaporates too much and the slump is low, which cannot meet the quality requirements, it can be appropriately added to the tank with water, and then rotated at a speed of 10-14 revolutions per minute for 30 minutes before unloading, allowing the concrete to be fully mixed.
6.攪拌車在空載中上裝罐體也不可以停轉，否則在行車過程中車輛的晃動很容易造成滾道和托輪部分磕碰的，這樣托輪和滾道就會過早的損壞。
6. The mixer truck should not stop when loading the tank body in an empty state, otherwise the shaking of the vehicle during driving can easily cause collisions between the roller and the supporting roller, which will cause premature damage to the supporting roller and the roller.
7.
自上料水泥攪拌車駕駛員要記住，在工作過程中壓力水箱的水一定要常常加滿，備用，在水箱加水前要打開氣閥將內部的空氣放掉，在沖洗車輛后或者停用時要將水箱內的空氣放掉。在冬天，工作結束后要將水箱內的水放掉，不得有剩水，否則容易結冰凍壞水箱。
7. The driver of the self loading cement mixer truck should remember that the pressure water tank must be frequently filled with water during the working process for backup. Before adding water to the water tank, the air valve should be opened to release the internal air. After flushing the vehicle or when stopping, the air in the water tank should be released. In winter, after work is completed, the water in the water tank should be drained without any remaining water, otherwise it is easy to freeze and damage the water tank.
8.水泥攪拌車在滿載混凝土?xí)r罐體正轉，如果需要反轉，就必須等罐體停穩后再將手柄扳到反轉位置。
8. When the cement mixer truck is fully loaded with concrete, the tank body rotates forward. If reverse rotation is required, the handle must be turned to the reverse position after the tank body stops stably.
自上料水泥攪拌車到工地上的注意事項就講解到這里了，還有什么疑惑或者需求，歡迎來我們網站
http://f3328.cn咨詢！
That's all for the precautions from loading the cement mixer truck to the construction site. If you have any doubts or needs, please come to our website http://f3328.cn consulting service
上一篇：防止自動攪拌車阻塞的步驟
下一篇：自動攪拌車各部件的生產結構的作用
