通常我們?cè)诰S修攪拌車時,只注意底盤的主要部件和上部的三個主要部件。電池也是混合器的非旋轉部分。今天,我想和大家分享一下攪拌機電池的保養程序。
Usually, we only pay attention to the main parts of the chassis and the three main parts of the upper part when we repair the mixer truck. The battery is also a non rotating part of the mixer. Today, I would like to share with you the maintenance procedure of mixer battery.
取下水泥自上料攪拌車電池的防塵罩,檢查電池和各極引線夾的固定情況。如果沒有松動,說明電池正常。用干凈的布擦拭電池外部,主要是面板和樁頭上容易引起泄漏的灰塵、油和一些白色粉末。
Remove the dust cover of the battery of the cement self loading mixer, and check the fixation of the battery and each pole lead clamp. If not, the battery is normal. Wipe the outside of the battery with a clean cloth, mainly the dust, oil and some white powder that are easy to cause leakage on the panel and pile head.
再次打開電池的注水蓋,檢查水位是否在正常位置。通常情況下,電池旁邊有高、低極限標記供我們參考。它需要仔細觀察。如果發現水位低于下限標志線,必須及時加入蒸餾水。如果一次沒有蒸餾水,也可以在緊急情況下注入過濾過的自來水。你不能加太多的水。標準是將其添加到行的中間。
Open the water filling cover of the battery again and check whether the water level is at the normal position. Generally, there are high and low limit marks beside the battery for our reference. It requires careful observation. If the water level is found to be lower than the lower limit mark line, distilled water must be added in time. If there is no distilled water at one time, it can also be injected with filtered tap water in case of emergency. You can't add too much water. The standard is to add it to the middle of the row.
檢查
水泥自上料攪拌車蓄電池充電是否正常。這可以用三個儀表來檢查。具體檢查方法是在發動機起動后測量?jī)杉?jí)蓄電池的電壓。電壓必須超過13V才能正常工作。如果發現充電電壓過低,建議是找檢查充電系統。用三次電表也可以,因?yàn)槟繙y(cè)也可以。
Check whether the battery of cement self loading mixer is charged normally. This can be checked with three gauges. The specific inspection method is to measure the voltage of the two-stage battery after the engine is started. The voltage must exceed 13V for normal operation. If the charging voltage is found to be too low, it is recommended to find an expert to check the charging system. It is also OK to use the three times electricity meter, because visual inspection is also OK.
發動機起動后,打開蓄電池水罩,檢查每個電池是否有氣泡。如果有氣泡,充電系統可能有問題。需要注意的是,檢查時會產生氦氣,但氦氣的化學性質相對穩定,正常情況下沒有問題。
After the engine is started, open the battery water cover and check whether each battery has bubbles. If there are bubbles, there may be a problem with the charging system. It should be noted that helium will be produced during the inspection, but the chemical properties of helium are relatively stable, and there is no problem under normal conditions.
水泥自上料攪拌車電池也需要定期檢查的相關內容就講到這里了,您可以關注我們網站
f3328.cn了解咨詢更多事項!
That's all for the regular inspection of the battery of the cement loading mixer. You can follow our website at www.sdzkjf Cn for more information!
上一篇:攪拌車的攪拌工作與事后維護
下一篇:攪拌車制動系統的5個須知常識