一、攪拌車拖輪是干什么的?
1、 What does the mixer tug do?
攪拌車拖輪是個軸承,用于把罐體支撐起來,與攪拌車是一體的,輔助攪拌。
The tug of the mixer truck is a bearing, which is used to support the tank and is integrated with the mixer truck to assist mixing.
二、攪拌車拖輪是干什么的?
2、 What does the mixer tug do?
一般不建議自己換,直接到售后點找專門的人員更換,而且使用的油需符合要求,不然對設備損害很大,使用壽命也會大大縮短,更換合理標號的液壓油。
Generally, it is not recommended to replace it by yourself. Go directly to the after-sales point to find a special person to replace it, and the oil used must meet the requirements, otherwise it will cause great damage to the equipment and greatly shorten the service life. Replace the hydraulic oil with a reasonable grade.
三、攪拌車罐體填充率跟罐體傾角有什么關系?
3、 What is the relationship between tank filling rate of mixer truck and tank inclination?
目前攪拌車傾角在12度左右,填充率為百分之六十三左右,傾角不好測量,填充率也很難計算。目前銷售的攪拌車都以有用的攪拌容積為準。
At present, the inclination angle of the mixer is about 12 degrees, and the filling rate is about 63%. The inclination angle is not easy to measure, and the filling rate is difficult to calculate. At present, the mixer trucks sold are subject to the useful mixing volume.
四、混凝土攪拌車罐不轉,轉開了沒力而液壓油從郵箱加油口噴出來是什么原因?
4、 What is the reason why the tank of the concrete mixer doesn't rotate and has no force when it is turned, but the hydraulic oil is sprayed out from the oil filler of the mailbox?
液壓一個進一個回,進沒力可能是油泵封閉部分壞了?;赜蜎_,可能是油泵封閉腳墊壞了。
The hydraulic pressure goes back and forth one by one. The lack of inlet force may be that the closed part of the oil pump is broken. The return oil flushes. The sealing foot pad of the oil pump may be damaged.
五、攪拌車攪拌筒的轉速是多少?
5、 What is the speed of the mixing drum of the mixing truck?
進料時攪拌筒的轉速是:6---10轉/分;攪拌時攪拌筒的轉速:6--10轉/分。
The rotating speed of the mixing drum during feeding is 6-10 rpm; Speed of mixing drum during mixing: 6-10 rpm.
六、8--12方的混凝土攪拌車進料口到地面距離是多少?
6、 What is the distance from the feed inlet of 8-12 m3 concrete mixer to the ground?
一般8--12方的攪拌車整車高度大概在3.8米左右,進料口距離地面就有3.5米左右,具體的根據不同的車型來定。
Generally, the height of 8-12 square mixer truck is about 3.8 meters, and the feed inlet is about 3.5 meters away from the ground. The details are determined according to different models.
七、水泥攪拌車怎么清洗罐?
7、 How to clean the tank of cement mixer?
攪拌車配的水箱,每次卸完料后就應該將水放入罐內,在返回時攪拌行使,到攪拌站后再將水排出接料。罐體外表應該在水箱加水時即可順便清洗。當然也可以直接用水箱內的水清洗。如果水泥漿已經凝固,罐體內找專門的清罐,外表凝固用草酸刷洗就行了。
For the water tank equipped with the mixer truck, the water shall be put into the tank after unloading each time, and the water shall be mixed when returning. After arriving at the mixing plant, the water shall be discharged and received. The surface of the tank should be cleaned when the water tank is filled with water. Of course, it can also be cleaned directly with the water in the water tank. If the cement slurry has solidified, find a special cleaning tank inside the tank, and brush the surface with oxalic acid.
The above highlights come from: self feeding cement mixer, and more highlights come from: http://f3328.cn Welcome to communicate with us.
上一篇:水泥攪拌車罐體停轉故障緊急處理措施!
下一篇:攪拌車打地坪工程中能使用嗎?